Every year people who plant trees install millions of tree protectors. The people who make such purchases often do so after listening to manufacturer claims and little else. While many of these claims are supposedly backed up by data, the data are often presented in a biased or incomplete way.

Nonetheless, it is true that trees with protectors are better off in the vast majority of cases than trees without any protection. It is not true that all protectors and shelters provide equal protection.

As a result of the lack of good, unbiased data, most tree planters are oblivious of the harm being done to their trees. Moreover, in many cases those who do the actual plantings do not return to the site to inspect the trees and are therefore not aware of the harm these protectors do.

The good that protectors do has been well established. Many studies (not included here) and countless applications attest to their success in protecting trees from animals, stimulating growth, etc.

The problem arises from the fact that not all protectors perform these functions equally well. Some actually harm, even kill the trees they're supposed to protect.

Primary functions are to promote tree health and improve survival. Secondary functions have to do with the growth rate of the tree.

Deer, mice, voles, and other critters damage and destroy millions of newly planted trees each year. Although many of these trees may cost less than a quarter apiece, the labor and overhead costs can be much higher. The cost of replacing dead trees is higher yet.

It is believed that the higher incidence of rodent infestation has to do with the cozier environment provided by some protectors. Unvented protectors that are pressed down into the ground are the worst offenders in this regard because they provide rodents with a warmer environment.

Tree health and survival have to do with more than protecting the trees from animals. As is shown below, protectors can create an environment that places tree health and survival at risk.

It's well-known that tree protectors accelerate growth.

Unfortunately, this growth is vertical only. Although a more rapid vertical growth rate is generally a good thing, there is a downside if the rate is excessive. Rapid vertical growth, without commensurate diameter growth, produces a stem that is sometimes too thin to support the canopy. This sometimes causes the top of the tree to snap off even in moderate winds.

While all protectors stimulate vertical growth, excessive vertical growth is a primarily a problem of the darker unvented shelters. Because they transmit less light, the tree will "concentrate" growth on the vertical in an effort to reach the light entering the top of the shelter.

With lighter colored vented shelters such as Tree Pro and Miracle Tube, enough light enters the protector wall to stimulate diameter growth.

Features are attributes that are intentionally designed into the protector. Characteristics, at least in this use of the term, include unintended consequences of a given protector design. Since it's sometimes impossible to separate the two, at least without having first-hand knowledge of the intentions of the designers of other protectors, we lump these two together.

For the purposes of this discussion, all attributes fall under the following categories:

Tree protectors and shelters create a "mini-greenhouse" inside the tube. Both temperature and humidity are generally higher on the inside than on the outside.

For years, many of us in the industry believed this was beneficial to the tree. Under ideal circumstances, it is. However, conditions are seldom ideal. Under real-world conditions, some tree shelters cause heat to increase inside the protector to such an extent that the tree is harmed and sometimes even destroyed.

A "closed" system; i.e., one in which the only air circulating into the protector is through the opening at the top, is not healthy for the tree. In order for photosynthesis to take place at the optimal rate, there must be a ready supply of fresh air. A closed system also promotes the retention of excessive heat and moisture inside the protector.

In late winter and early spring, some of these protectors; e.g., the darker, unvented type, cause the trees to emerge from dormancy. In direct sunlight over a period of days, even in January, it can get warm enough inside the shelters for the trees to come out of dormancy prematurely. That often results in death and dieback when the temperature drops again.

The reverse happens in the fall when the trees are supposed to go dormant. Instead, some protectors (again, the non-vented kind with darker, less translucent colors) retain heat, which delays the trees from going dormant.

As a result, when the outside temperature drops into the low 20s, dieback and worse often occur because the trees haven't yet gone dormant.

TREE PRO (the company) manufactures two different tree protection tubes. One is Tree Pro tree protectors. The other is Miracle Tube tree shelters.

Tree Pro protectors are furnished flat and are formed into tubes when they are installed around the trees. Miracle Tube shelters are solid tubes that are furnished in nested groups of five units, one inside another of a slightly larger diameter.

Both Tree Pro and Miracle Tube designs eliminate the Greenshouse Effect's detrimental impact while retaining its benefits. They have just the right color (hue and value) to prevent the absorption and retention of excessive heat. They have exactly the right amount of translucency to admit the proper amount of light.

In addition, the right number and size of holes have been drilled into the sides of these protectors. This allows the right amount of fresh air to circulate through the protector.

With unvented tubes, the only way that excessive heat build-up can be dissipated is by lifting them. This labor-intensive exercise requires each lock-tie to be loosened, which after a couple years can cause some of them to break. Worse, if the shelter was pressed down into the ground when it was installed, it must now be twisted back and forth to break loose from the soil compacted around it. When temperatures stabilize, the tube must then be lowered, then raised again to accommodate the change in seasons. 

It should be noted that lifting shelters may not necessarily solve the problem. In certain hot, dry conditions, lifting the shelter produces a "chimney effect," which can cause the leaves to become dessicated. 

During the summer, the temperature inside some tree protectors can be more than 30 degrees Fahrenheit higher than ambient temperatures. At that temperature, the trees' leaves turn black and fall off. The trees suffer dieback, lose their disease-resistance and sometimes even die. 

Some tree protectors are worse than others. To overcome this tendency to "trap" heat, both Tree Pro and Miracle Tube are light in color (thereby absorbing less heat) and if specified, can be furnished with ventilation holes to improve the dissipation of heat.

Translucence refers to the amount of diffused sunlight transmitted through the protector wall and is a function of the opacity and color of the material used. Clear material transmits most of the light while dark-colored opaque material transmits very little.

Anecdotal evidence, trial and error experience, as well as some studies have generally arrived at a consensus that the ideal protector transmits between about 25 and 50 percent of the available light. This mimics the natural habitat in which a seed germinates beneath a forest's canopy.